![background image](http://html1.mh-extra.com/html/yacht-devices/ydeg-04/ydeg-04_user-manual_3081541039.webp)
— 39 —
37. TRIM_ZERO=x
x – calibration value of 0% tilt/trim position, 0..65534
Factory setting: 28708
The Gateway process three different messages with tilt/trim data depending on the current settings.
Switching on/off SMARTCRAFT or MEFI4B setting (V.35-36) resets the value to default for SmartCraft,
MEFI or Volvo Penta EVC systems. This value corresponds to zero tilt/trim angle of the engine. See V.39.
38. TRIM_STEP=x
x – calibration value of 1% step of tilt/trim, -30000..30000 (except 0)
Factory setting: 128
The Gateway process three different messages with tilt/trim data depending on the current settings.
Switching on/off SMARTCRAFT or MEFI4B setting (V.35-36) resets the value to default for SmartCraft,
MEFI or Volvo Penta EVC systems. This value corresponds to a 1% step of tilt/trim angle of the engine.
See V.39.
39. CALIBRATE_TRIM=x
x – current tilt/trim of the port engine (ENGINE_0), from -100 to 100 (in percent)
Factory setting: not applied
This setting is not saved to the configuration or to the YDEGSAVE.TXT file; it is used to specify the current
tilt/trim angle of the port engine (ENGINE_0) to update V.38-V.39 settings with actual data.
Negative trim angle is not supported by most MFDs, and it is recommended to calibrate the tilt/trim
to a range of 0..100%. To begin, set the port engine to the lowest position, and load the configuration file
with the single line:
CALIBRATE_TRIM=0
Содержание YDEG-04
Страница 10: ...10 Figure 1 Device with MicroSD card pin side visible at left label side at right...
Страница 49: ...49 Figure 1 Raymarine c125 MFD devices list with Gateway YDEG 04...
Страница 63: ...63 Appendix E Device Connectors Figure 1 NMEA 2000 connectors of the YDEG 04R left and YDEG 04N right models...