Yacht Devices YDEG-04, Руководство пользователя, Страница: 35 / 68

— 35 —
26. EDC2=x
x – OFF (default value) or ON
Turn on or off experimental support of EDC II. Volvo Penta engines with EDC II use a J1939 interface
for engine synchronization only. This means that the port engine sends actual revolutions,
and the starboard engine listens and synchronizes revolutions. Unfortunately, other data are not present
on the J1939 interface. You can connect YDEG to a sync cable (yellow/white is CAN HIGH, yellow/grey
is CAN LOW) and even «emulate» twin engines for chart plotters:
EDC2=ON
ENGINE_0=0
ENGINE_1=0
With the above settings, you can see two engines on your chart plotter, but actually both RPM gauges
will show port engine data. Please, see setting V.29 to learn more about EDC II engines support.
27. PASS_PGN=x
x – empty or list NMEA 2000 or J1939 PGNs separated by comma
Factory setting: empty
Forward specified messages from an engine network to a NMEA 2000 network (see also V.32-33). Many
motorboats have NMEA 2000 transducers installed in an engine network, and YDEG allows forwarding
of this data and display on the chart plotter (see the next setting also).
To forward water depth (NMEA 2000 PGN 128267), speed through water (PGN 128259), and water
temperature (PGN 130310), add the following line to the YDEG.TXT file (up to 20 PGNs can be specified):
PASS_PGN=128267,128259,130310
28. PASS_ADDR=OFF|YDEG|AS_IS|n
n – number from 0 to 253