— 11 —
III. Installation and Connection to NMEA 2000 Network
The Device requires no maintenance. When deciding where to install the Device, choose a dry mounting
location. Avoid places where the Device can be flooded with water, this can damage it.
The Device is directly connected to the network backbone without a drop cable. Before connecting
the Device, turn off the bus power supply. Refer to the manufacturer’s documentation if you have
any questions regarding the use of connectors:
• SeaTalk NG Reference Manual (81300-1) for Raymarine networks
• Technical Reference for Garmin NMEA 2000 Products (190-00891-00) for Garmin networks
After connecting the Device, close the lock on the connection to ensure its water resistance and reliability.
The Device has an LED which flashes red or green. After turning the power in the NMEA 2000 network
on, the Device’s LED will give a series of 2 flashes 5 seconds apart. If this does not happen, see Appendix A.
If your boat has no NMEA 2000 network installed, you should establish a basic NMEA 2000
network first. You cannot simply connect the Gateway to a NMEA 2000 port of your chart
plotter. Many manufacturers offer a “Starter Kit” which contains all that is necessary to
establish a basic network and connect two devices:
•
for Raymarine SeaTalk NG, see Raymarine part number T70134;
•
for NMEA 2000, see Garmin part number 010-11442-00.
Содержание YDEG-04
Страница 10: ...10 Figure 1 Device with MicroSD card pin side visible at left label side at right...
Страница 49: ...49 Figure 1 Raymarine c125 MFD devices list with Gateway YDEG 04...
Страница 63: ...63 Appendix E Device Connectors Figure 1 NMEA 2000 connectors of the YDEG 04R left and YDEG 04N right models...