Ver.1
April 2016
P 6
da Vinci
First retrieve filament spool to install the filament
spool axle ring.
Place the assembled filament spool (with the spool axle
rings) on the filament holder on the left side of the printer.
Pull out a section of the filament and insert it into the
feed port.
Caution: Pay attention to the direction the
filament is being pulled out and ensure that the
filament spool axle is being rotated in the correct
manner.
Open the release arm and push the filament all the way
to the bottom so that the front end of the filament is
completely inserted into the feed module.
Take out and separate the filament spool
axle ring into its two components.
Install the sensor chip. Please pay special attention to
the position of the installation holes on the chip.
Insert the filament spool axle ring components
to either side of the filament spool, and use a
cruciform screwdriver to tighten and secure the
rings to the axle to complete the installation of
the filament spool axle rings.
1
2
3
4
5
6
7
Load Filament
CHANGE SPOOL
