Xylem WTW Multi 9430, Руководство по эксплуатации

Страница: 85 / 132

Multi 9430 Settings
ba75966e04 04/2015
85
Alternative temperature on
off
Takes the measured temperature value from an IDS sen-
sor.
This menu item is only available if an IDS adapter and an
IDS sensor with temperature sensor are connected.
Temperature from
channel
▭▭▬
▭▬▭
▬▭▭
Selection of the channel from which the temperature value
should be taken over.
This menu item is only available if two IDS sensors are
additionally connected.
Man. temperature -25 ... +25 ...
+130 °C
Entry of the manually determined temperature.
This menu item is only available if an IDS adapter is con-
nected.
pH resolution 0.001
0.01
0.1
Resolution of the pH display
mV resolution 0.1
1
Resolution of the mV display
Limit monitoring With the Limit monitoring function you define the mea-
sured values whose exceeding is signaled. An acoustic
signal sounds, and at the same time a message is output
to the USB interface.
You can switch on or off the acoustic signal in the
System
menu (see section 9.6.1 S
YSTEM
, page 95).
Limit monitoring /
pH monitoring
on
off
Switch on or off the limit signaling device for the pH value.
Limit monitoring /
TP monitoring
on
off
Switch on or off the limit signaling device for the tempera-
ture value.
Limit monitoring /
pH monitoring
/
on /
pH upper limit
-2 ... 20 Upper limit. A message is output to the USB interface if it
is exceeded.
This menu item is only visible when the
pH monitoring set-
ting is active.
Limit monitoring /
pH monitoring
/
on /
pH lower limit
-2 ... 20 Lower limit. A message is output to the USB interface if it
is exceeded.
This menu item is only visible when the
pH monitoring set-
ting is active.
Limit monitoring /
TP monitoring
/
on /
TP upper limit
-5 ...
+105 °C Upper limit. A message is output to the USB interface if it
is exceeded.
This menu item is only visible when the
TP monitoring set-
ting is active.
Limit monitoring /
TP monitoring
/
on /
TP lower limit
-5 ... 105 °C Lower limit. A message is output to the USB interface if it
is exceeded.
This menu item is only visible when the
TP monitoring set-
ting is active.
Menu item Possible
setting Explanation