Xylem SI Analytics ViscoClock plus, Руководство по эксплуатации

Страница: 21 / 36

51
4 Description and use of software
4.1 Display
The main screen (

Fig. 11 ) of the ViscoClock plus displays all relevant information clearly on a graphics
display.
Fig. 11 Display ViscoClock plus
The flow time (max. 999.99 s) is displayed in large digits in the upper section (
A ).
Below this, there are important parameters for the documentation of the measuring results,
such as sample and viscosity number as well as the date and time (
B to D ).
The bottom line is used to display the status information (
E to J ).
4.2 Keys
The ViscoClock plus is operated via a total of 4 keys:
<START> (16): Start/stop measurement
<SET> (14): Save/print, set/confirm parameters
<↓>
(13): elect sample number, decrease parameters
<↑>
(15): Select viscosity number, increase parameters
The following sections will show more information about the different key functions.
4.3 Set time / activate sounds
If you press the <SET> key for a long time, you will be in the setup mode.
The selected parameter will blink and can be changed via the
<↑>
and
<↓>
keys.
You press <SET> again: the set parameter is taken over and you will get to the next parameter.
After setting the time ( D ), the last parameter will be the activation of the beeper ( F ).
If there is no new entry for 8 seconds, the value is saved automatically and the mode will be
exited.
For early saving, press the <SET> key.
A : Measuring time (flow time)
B : Sample number (S=Sample)
C : Viscometer number (V=Viscometer)
D : Time/date
E : Number of measurements (internal memory)
F : Beeper on/off
G : Status of USB memory
H : Status USB printer
I : Status PC connection
J : Detection light barrier:
Status upper or lower light barrier
(start or stop signal).