Chapter 3-Installation
3-19
If you had Windows NT preloaded on your system, you may have to
purchase and install an external parallel port CD-ROM drive to install
Windows NT drivers. The Windows NT operating system only ships on
CD-ROM.
Using a Touchscreen
Xycom Automation’s touchscreen complies with environmental specifications and
maintains a NEMA 4 seal when panel mounted. It remains operational even after 30
million touches. The touchscreen Monitor Mouse driver emulates a Microsoft
mouse.
Note
If MS-DOS, or Windows 95 is installed on your system, the touchscreen
is configured for the mouse port and the mouse port is unavailable.
If Windows NT is installed on your system, the touchscreen is set up on
COM2 and the COM2 port is unavailable for other use.
To reconfigure the touchscreen to use the COM2 port, perform the following steps:
1.
Disconnect the power.
2.
Remove the lid.
3.
Remove the touchscreen controller card (Figure 3-15).
Figure 3-15. Touchscreen controller card.
4.
Reconfigure Jumpers J1-J5. Position A = COM2. Position B = PS/2 mouse.
5.
Reinstall the touchscreen controller card.
6.
Reboot the computer.
