3510/3510KP/3512/3512KP System Manual
3-8
7.
Turn on power to the system. The system will boot up to the operating system
installed.
8.
Install the application software via a floppy drive.
If a touchscreen has been factory installed along with MS-DOS, the mouse port is
unavailable. The unit will arrive with a sticker placed over the port. If you would like
to reconfigure the touchscreen to use the COM2 port, follow the instructions in the
Using a Touchscreen
section in this chapter.
Installing Internal Hardware Options
Caution
Turn off the unit before installing internal hardware.
Warning
The installation of expansion boards may void safety and/or EMC
compliance.
Remove the lid to install internal hardware options.
DRAM and Additional DRAM Single In-line Memory Modules (SIMMs)
You can order your system CPU factory-configured for many configurations of
DRAM. You can reconfigure the DRAM capacity by changing the DRAM SIMMs
on your board. For more information, refer to the CPU manual.
PC/AT and PCI Boards
1.
Check that the memory and I/O configuration of the board you want to install
does not conflict with the CPU and I/O memory maps in your CPU board
manual.
2.
Remove the lid.
3.
Remove the ORB screw in the desired track.
4.
Slide the PC/AT expansion board into a corresponding rail.
5.
Push the board into the backplane connectors.
Note
Do not
force the boards or apply uneven pressure.
