5.
Slide the card into the slot. Push down on the card evenly until it firmly rests in
the card cage connectors.
Note:
DO NOT force the card or apply uneven pressure.
6.
Secure the card's ORB to the 1614 by replacing and tightening the screw that was
removed.
INTERNAL DRIVE OPTIONS
To Add or Replace 5.25" Devices
1.
Check that the memory, I/O configuration, and processor requirements for the de-
vice you want to install do not conflict with the CPU and memory maps of boards
already installed in your system. If you must install an additional controller card,
verify that its requirements do not conflict either. Refer to pages 44-48 for informa-
tion about the SBC-370 and SBC-SLOT1 boards.
Warning:
To prevent any component damage or injury, please make sure your 1614
unit is completely powered down before performing any installation or maintenance
and wear a ground wrist strap or other static-dissipating device.
2.
Remove the top cover as described on page 12.
3.
Remove the hold-down bar by removing the seven screws securing it (two connect-
ing the hold-down bar to the 5.25" drive bay, two on the left side when facing the
front panel, and three on the right side when facing the front panel). Lift the bar
out of the unit.
4.
Remove device and power cables if they're already connected to existing devices.
5.
Remove the two screws securing the 5.25" drive bay to the front panel.
6.
Slide the 5.25" drive bay approximately 1" towards the back of the chassis.
Hardware Options
21
