Brand or product names are trademarks or registered trademarks of their respective owners.
Windows and Windows NT are registered trademarks of Microsoft Corp. in the United States and other countries.
This document is copyrighted by Xycom Automation, Incorporated (Xycom Automation) and shall not be reproduced or
copied without expressed written authorization from Xycom Automation.
The information contained within this document is subject to change without notice. Xycom Automation does not guaran-
tee the accuracy of the information.
United States FCC Part 15, Subpart B, Class A EMI Compliance Statement:
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency en-
ergy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
For European Users: WARNING
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
INSTALLATION: ELECTROMAGNETIC COMPATIBILITY WARNING
The connection of non-shielded equipment interface cables to this equipment will invalidate FCC EMI and European Union
EMC compliance and may result in electromagnetic interference and/or susceptibility levels which are in violation of regu-
lations which apply to the legal operation of this device. It is the responsibility of the system integrator and/or user to ap-
ply the following directions which relate to installation and configuration:
All interface cables must include shielded cables. Braid/foil type shields are recommended. Communication cable connec-
tors must be metal, ideally zinc die-cast backshell types, and provide 360 degree protection about the interface wires. The
cable shield braid must be terminated directly to the metal connector shell, ground drain wires alone are not adequate.
Protective measures for power and interface cables as described within this manual must be applied. Do not leave cables
connected to unused interfaces or disconnected at one end. Changes or modifications to this device not expressly ap-
proved by the manufacturer could void the user's authority to operate the equipment.
EMC compliance is, in part, a function of PCB design. Third party add-on AT/XT peripheral PCB assemblies installed within
this apparatus may void EMC compliance. FCC/CE compliant PCB assemblies should always be used where possible. Xycom
Automation can accept no responsibility for the EMC performance of this apparatus after system integrator/user installation
of PCB assemblies not manufactured and/or expressly tested and approved for compliance by Xycom Automation. It is the re-
sponsibility of the system integrator/user to ensure that installation and operation of such devices does not void EMC compli-
ance.
BATTERY REPLACEMENT CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's instructions.
CPU REMOVAL AND REPLACEMENT CAUTION:
Use caution when removing the CPU from its board. After removing the DRAM, carefully slide the CPU from its position
without bumping or bending components behind or around the CPU.
2
