Power connector:
For AC power units, the standard power cord must be securely posi-
tioned before turning power ON. The 1614's autoranging AC power supply requires no
switch adjustment. For -48 volt DC units, the positive, negative, and ground wires
must be properly connected to the corresponding holes.
•
Refer to page 40 for power connector pin assignments.
•
Refer to page 30 for proper AC power cord installation.
•
Refer to page 30 for instructions on creating a DC power supply cable.
Parallel port:
A printer usually interfaces with the system through this 25-pin connector.
•
Refer to page 40 for parallel port pin assignments.
PS/2 keyboard and mouse connector:
Both a keyboard and a mouse can be connected to this
PS/2 compatible port through the Y adapter cable included with your unit; connect a
mouse into the cable labeled
M
and a keyboard into the cable labeled
K
(see figure 4).
If connecting only a keyboard, you can connect directly to the PS/2 compatible connec-
tor on the rear of the unit. If connecting only a mouse, the mouse must be connected
using the Y adapter cable port labeled
M.
•
Refer to page 43 for the keyboard/mouse connector pin assignments.
Note:
Do not connect a keyboard to this rear connector if a keyboard is plugged into the
keyboard connector on the front panel. Doing so may cause the keyboards to operate
improperly.
11
Product Overview
Figure 3. Rear view.
A, Power connector
B, Parallel port
C, PS/2 keyboard and mouse
connector
D, COM1 serial connector,
RS-232
E, Ethernet port
F, Video connector
G, COM2 serial connector,
RS-232
H, Fan Outlet grille
A
H
B
G
F
C
D
E
K
M
Figure 4. Y adapter cable for
rear keyboard and mouse
connector.
