XVTEC XVC-ULTRA, Руководство пользователя

Страница: 45 / 50

XVC-ULTRA Encoder User’s Guide
Page 45 of 50
5.3.3 System recovery procedure
1. Disconnect the input power connector to power down the unit.
2. Reconnect the input power while pressing and holding down the SW button for
approximately 20 seconds. Pay attention to the behavior of the LEDs:
•
After approximately 10 seconds, all LEDs appears in blinking orange .
•
After approximately 20 seconds, all LEDs appears in solid orange (no blinking). At this
point, release the SW button to start the system recovery.
•
Once the XVC-ULTRA has loaded in recovery mode, the STAT LED will turn on solid
green and the rest of the LEDs will be solid orange .
Figure 40: System Defaults Successfully Restored
The recovery process automatically configures the encoder’s network settings as follows:
•
IP address: 192.168.1.100
•
Subnet mask: 255.255.255.0
The system boots using the new network settings.
NOTE
System recovery mode should be entered only when:
1. The unit stops functioning correctly
2. The web interface is stuck, or the unit can’t not be reached with the XVC management tool.
NOTE
The host’s (your PC’s) IP address must be set to the same IP domain as the encoder to access the
encoder. For example, you can set the PC’s IP address to: 192.168.1.101