XtremeAIR XTA-PC30, Руководство по установке и инструкция пользователя

Страница: 5 / 12

INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
5. For NG models the gas supply is connected to the regulator loose.
The inlet connection has a 1/
2” B.S.P. male thread. IT IS ESSENTIAL
THAT THE ELBOW ON THE APPLIANCE BE HELD FIRMLY WITH A SPAN-
NER WHEN CONNECTING THE SUPPLY. DO NOT OVER TIGHTEN. The
regulated
pressure for NG is 4” W.C. (See Fig. 5).
6. For gas inlet position of appliance refer Fig 5, 6 and 7. After in-
stalling the gas supply and making all connections, check thoroughly
for possible leaks. Turn all control knobs on the unit to
‘OFF’ position.
Open the valve on the gas supply. Using a soap and water solution
check each gas connection one at a time, by brushing the solution over
the connection. Presence of bubbles will indicate a leak. Tighten the fit-
ting and re- check for leaks. If it is not possible to correct the leak, re-
place fitting. Under no circumstances should matches or flames be
used for checking leaks. It is essential that the gasket and the pressure
test point stopper are properly installed to avoid gas leakage.
7. To checking inlet pressure at the appliance, perform the following:
a) Disconnect electric power before checking pressure.
b) Take off one of the gas burner cap and the relative flame spreader
in order to gain access to the burner injector.
c) Put the pressure detector directly on the burner injector. Afterwards,
open the relative burner knob at maximum position keeping it pressed,
then measure the outlet pressure from the burner injector.
d) Once the pressure checking has been carried out, replace the burner
cap and flame spreader in the correct and original
8. Turn on appliance control and light each burner. Check for a
clear blue flame without yellow tipping. If burners show any
abnormalities, check that they are situated properly and in line with
the injector nipple.
9. Sometimes the burners will not ignite immediately and seem
to "blow" slightly when they do ignite. This is usually due to air in
the gas lines, which will clear itself within minutes of use.
10. If after following the instructions given, satisfactory
performance cannot be obtained, contact your local gas authority for
advice and assistance.
ELECTRICAL CONNECTION
The connection of the hobs to mains is effected via the flex and the
three pin plug located underneath the hotplate. The appliance operates
at a main voltage of 120V a.c., frequency: 60Hz. Electric power
absorption is about 1W for 5 gas burners version or 2W for 6 gas
burners version.
WARNING
Electrical Grounding Instructions: This appliance is equipped with a
(three-prong) grounding plug for your protection against shock
hazard and should be plugged directly into a properly grounded out-
let. Do not cut or remove the grounding prong from this plug.
WIRING DIAGRAMS (see Fig. 12.)
Wiring diagram description:
1. Cable terminal
2. Ignition switch
3. Spark generator
4. Ignition spark L. Black N. White T. Green (earth)
8 9