CARE INSTRUCTIONS
CARE INSTRUCTIONS
CLEANING THE COOKTOP
Periodically clean the burner heads, the cast iron pan supports and the
burner caps using warm water. Remove burned food and fat residues
with a rubber spatula . If food residue prevent the smooth operation of
the control knobs, call the customer service hotline to schedule service
by a factory-trained professional.
CLEANING THE STAINLESS STEEL
For best results use a stainless steel cleaner product with a soft
sponge or wipe. Alternatively use a soft sponge or cloth with a warm
soap and water solution. Never use abrasive
powders or liquids!
CLEANING THE BURNER CAPS
Lift the burner caps from the burner heads and wash them in a warm
soap and water solution. Dry thoroughly before using them again. Be-
fore reinstalling them on the burner head, check that the gas flow holes
are not clogged with food residues or cleaning product residues.
ATTENTION:
For further details about cleaning of the appliance,
please contact your appliance retailer.
SERVICE & MAINTENANCE INSTRUCTIONS
Service and maintenance only to be carried out by authorized
professional.
To replace parts such as burners, valves and electric components, the
cooktop must be removed from the countertop by releasing the at-
tachment hooks, loosening the attachment screws of each burner, un-
screwing the cooktop attachment nuts which are visible at the bottom
of the surface, removing the cooktop stainless steel top, and finally re-
placing the defective parts.
NOTE:
If the valves must be replaced, first disassemble the ignition
switches wires. It is recommended to replace the valve gaskets each
time the valve is replaced, thus ensuring a perfect seal between the
body and the gas manifold.
WARNING:
Disconnect power before servicing unit. For the location of
the wall receptacle for the three-prong grounded plug of the appliance,
see Fig. 1- 2.
WARNING:
After first installation of the appliance or after any service
intervention concerning main gas parts of the appliance, perform
leak test using water with soap on the gas connections in order to verify
proper installation. Do not use fire for gas leak testing.
GREASING THE VALVES
If it becomes difficult to operate the valve, it should be greased immedi -
ately by following the steps below:
1.
Disassemble the valve body by loosening the two screws located on
the body of the valve. (See Fig. 13).
2.
Extract and clean the seal cone and its housing with a rag
soaked with thinners.
3.
Lightly grease the cone with a special grease.
4.
Insert the cone, moving it several times, remove it again, remove
the excess grease and make sure that the gas passage ways are
unobstructed.
5.
Replace all the pieces in reverse order and check that the valve oper-
ates correctly.
16
17
Содержание XTA-PC30
Страница 11: ...REFERENCE FIGURES Fig 8 Fig 9 Fig 10 Fig 11 Fig 12 Fig 14 Fig 15 Fig 13 20 21...
Страница 12: ......
