PHOTO F
PHOTO G
PHOTO E
PHOTO D
HANGING YOUR FIXTURE
• The lamp may require 10-30 minutes cooling time before restarting.
• After you plug the reflector in, the bulb may require several minutes to reach its full brightness. In the
event of a momentary power interruption, the bulb will not restart immediately.
• Some variation in the color of light emitted by the bulb is not unusual, especially in the first 100
hours of operation.
• Never pull the cord to unplug the reflector, pull the plug only.
• Avoid scratching the bulb, subjecting it to undue pressure, or getting it wet when it is hot; these
actions may cause the bulb to break.
TIPS
1. Make sure your unit is unplugged.
2. Install rear hanging eye hook to threaded stud on top of the ballast. Tighten with adjustable
wrench. (see images below)
3. Hang the fixture from a strong cord or chain from both ends. Make sure you have hooks solidly
screwed into the studs in the ceiling. If you cannot locate the studs, insert expansion anchors
into the ceiling. The hooks should be rated to hold at least 50 lbs each.
5
