Xtralis ICAM IFT-P, Руководство по эксплуатации продукта

Страница: 5 / 48

ICAM by Xtralis
ICAM IFT-P Product Guide
www.xtralis.com iii
Codes and Standards Information for Air Sampling Smoke Detection
We strongly recommend that this document is read in conjunction with the appropriate local codes and standards
for smoke detection and electrical connections. This document contains generic product information and some
sections may not comply with all local codes and standards. In these cases, the local codes and standards must
take precedence. The information below was correct at time of printing but may now be out of date, check with your
local codes, standards and listings for the current restrictions.
FDA
This ICAM product incorporates a 658 nm laser device with an average power less than 10 mW, and is classified as
a Class 1 laser product that complies with FDA regulations 21 CFR 1040 with deviations pursuant to Laser Notice
50, and with IEC / EN 60825-1. Access to the laser chamber is on the underside of equipment and is restricted by
cover. The cover may only be removed by qualified personnel. The laser emits visible light and can be hazardous if
viewed with the naked eye.
CAUTION - Use of controls or adjustments of performance or procedures other than those specified herein may
result in hazardous radiation exposure.
ATTENTION - L'utilisation de commandes, réglages de performances ou procédures autres que celles
mentionnées dans ce manuel peut conduire à une exposition dangereuse aux radiations.
Laser Chamber Safety
ICAM IFT-P detector laser chambers incorporate a 658 nm laser with an average power less than 10mW and are
located on the underside of the detector when mounted upright on a wall. The laser chamber is identified by two
safety labels shown in the following diagrams.
Laser Chamber Safety Labels
Warning: The laser emits visible light and can be hazardous if viewed with the naked eye. Under no
circumstances should the detector chamber be opened except by qualified personnel.
Avertissement : Le laser émet de la lumière visible et peut être dangereux en cas d'observation à l'oeil nu.
En aucun cas la chambre du détecteur ne doit être ouverte par qui que ce soit d'autre que
du personnel qualifié.