Xtrails ADPRO 49841000, Техническое руководство

Страница: 14 / 20

Network I/O Units – Technical Manual ADPRO
14 33355_00
It may, for example, damage input/output 1 (relay permanently active) and send incorrect signals to the ADPRO
NVR+ device.
Proceed as follows before plugging or unplugging extension units:
l
If the base unit is powered via a local power adapter: unplug the power adapter from the base unit.
l
If the base unit is powered via PoE: unplug the network (Ethernet) cable from the base unit.
After plugging or unplugging the extension units, plug the power adapter or network cable back in.
2.3 Setting the Base Unit IP Address
The default IP address of the base unit is 192.168.1.100 with subnet mask 255.255.255.0. The three system
LEDs on the base unit will light up simultaneously if the unit is still set at the default address.
The extension units do not have an IP address. You assign them an address (or sequence number) using the DIP
switch on the unit. For details, see
Connections and Adjustments on page 12.
Use the NetFinder tool to locate all base units on your network and set their IP addresses. You can find the
NetFinder tool on the DVD that comes with your ADPRO NVR+ device, or on the Xtralis Security site
www.xtralissecurity.com .
Caution!
NetFinder will not detect units behind a router. Make sure that your PC and the units are in the same
IP network segment.
To set the base unit IP address, proceed as follows:
1. Start NetFinder on your PC.
2. Click Search .
NetFinder will indicate the Net I/O units in green. The unit's firmware version is indicated between
parentheses.