16
GENERAL MAINTENANCE
The safety of this product can be maintained only if regular periodic checks are made. Most checks can be
performed once a week. However, some checks should be made before each workout, and are indicated as such
below.
Checks
Check that pedals hardware is secure, hardware can work loose over time.
Check that stabilizer bolts are tight, check before each workout.
Check that sliding rail is secure, if not, tighten, check before each workout.
Should a part become defective, replace it immediately. Do not allow use of the equipment until it has been
repaired.
Cleaning
A damp cloth is sufficient to clean most surfaces of this unit. Be careful not to drip water on the monitor. A mild
liquid soap may be added if needed.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. To adjust
the reed switch, the chain cover(9&10) must first be removed.
The first step to remove the adjust knob(47).
The second step to remove the two self-tapping screws (76) from each side of chain cover (9&10). And then
Remove another eight ST4.2 x 19 self-tapping screws (75) from each side of chain cover (9&10).
The third step is to loosen the screw (90), rotate the sensor bracket (18) aligned with the magnet on the
pulley until the computer receive signals and tighten the screw (90).
The last step is to attach the chain cover(9&10) on main frame.
HOW TO ADJUST THE DRIVE BELT
If you can feel the flywheel slip while you are pulling, even when the resistance is adjusted to the
highest level, the drive belt may need to be adjusted.
To adjust the drive belt, the chain cover(9&10) must first be removed.
The first step to remove the adjust knob(47).
The second step to remove the two self-tapping screws (76) from each side of chain cover (9&10). And then
Remove another eight ST4.2 x 19 self-tapping screws (75) from each side of chain cover (9&10).
The third step is to loosen or tighten the nut (58) to adjust the belt tension.
The last step is to attach the chain cover(9&10) on main frame.
76
76
75
75
75
75
75
76
76
47
10
58
58
18 90
40