EX-SDI DVR OPERATION MANUAL
- 5 -
`
1.5
Boot
DVR is correctly installed and plugged in, the power led is lit, video recorder will automatically turn on. Show
slightly different under different types of device power state , please refer to the front panel section of this article.
DVR boot process will automatically detect the device hardware state, boot process takes about 20 seconds. Power-on
complete devices after the buzzer was given a "beep" tone, and enter the screen real-time video surveillance state,
equipment operation or configuration can be at this time. Please refer to 4.2 main menu introduction and subsequent
introduction.
If the start-up time within the video to set the time, the system will automatically start a scheduled recording function.
Note: Please use the DVR power supplied, you may not use other types of branded power supply instead of the
original power supply.
1.6
Shutdown
Turn off the device, soft and hard switches. Soft-switch, go to "main menu" > "shut down the system" select
"close"; hard switching, hard and directly pull out the power cord when the switch is off. (Hard switching may
result in data loss, please use caution) reminder: replace the button battery on the motherboard you need to save the
configuration, or configuration information will be lost. During shutdown, press the front panel opening key turn off
the device. Enter the "main menu"-"shut down the system"-select "device off"
Figure 1-1
Note: replace the hard disk operation should be off the device and disconnect the power before proceeding.
1.7
Power Recovery
When video card video under operating conditions, if power to the system is cut off or been forced to shut
down, reconnected power, VCRs will be automatically saved before powering down the video and automatically
restore power before working status to continue to work.