Xstream X-HWTR3524GEN, Руководство по эксплуатации

Страница: 19 / 40

19
WARNING
THE TRIGGER GUN SHOULD ALWAYS BE LOCKED IN THE OFF
POSITION WHEN NOT IN USE! NEVER LOOK DIRECTLY AT THE
NOzzLE UNLESS IT IS DISCONNECTED FROM THE TRIGGER
GUN/DUAL LANCE ASSEMBLY!
installation & preparation
NOZZlE REVIEW
Various nozzles may be quick-connected into the end of the dual lance to
change the spray pattern. The detergent nozzle has been pre-installed at
the factory. When using quick-connects (Q.C.), be certain the connection
is securely locked as shown at right. If not, the high pressure water may
shoot the nozzle from the lance, causing severe injury or serious dam-
age. To determine spray fan, refer to the actual number stamped on the
nozzle. The first two digits indicate the spray fan degree: 00=0°, 15=15°,
25=25°, 40=40°, 65=65°.
1. The 0° nozzle (RED): This is a blasting nozzle. It delivers a very con-
centrated stream of water. Be cautious when using the straight narrow
stream. It is not recommended for use on painted or wood surfaces,
or items attached with adhesive backings. Uses: Removing weeds
from sidewalk cracks, stubborn stains from concrete, masonry, alumi-
num and steel, caked mud from equipment, and cleaning lawn mower
undersides.
2. The 15° nozzle (YELLOW): This is a chiseling nozzle. The spray should
be directed at a 45° angle to the surface and used like a scraper to
remove paint, grease and dirt. Uses: Surface preparation (removing
mildew stains and paint chips).
3. The 40° nozzle (WHITE ): This is a wash nozzle. This wide spray
pattern disperses the water pressure over a large area and is recom-
mended for moderate washing. Uses: Washing down aluminum siding,
cleaning windows, washing vehicles, spraying sidewalks, driveways,
and patios.
4. The 25° nozzle (GREEN ):
a. On standard units, this is a flushing nozzle. This pattern is best suited
for flushing dirt, mud, and grime. Uses: Wet sweeping leaves from
walks, curbs and driveways, cleaning stable floors, washing swimming
pool bottoms, degreasing engines.
b. On units with steam option, this nozzle is used for 250°F Wet Steam
operation. This nozzle is sized for operation with the unloader and
steam valve (where applicable) to provide high pressure wet steam.
Replacement of this nozzle with an improperly sized nozzle may cause
operational problems with the machine.