Xstream X-HWTR3524GEN, Руководство по эксплуатации

Страница: 24 / 40

24
operation
1. Follow the steps 1-7 outlined for “START-UP/COLD WATER
OPERATION”.
2. Move the Burner switch to the ON position.
3. Recheck the system for fuel leaks. If a fuel leak is found, TURN
MACHINE OFF IMMEDIATELY! See “Risk of Explosion or Fire”
warnings. Be sure that all damaged parts are replaced and that all
mechanical problems have been corrected prior to operation of the
unit. Contact Customer Service if necessary.
STEAM - 250°F:
The 25° (GREEN) steam nozzle is used for 250°F Wet Steam operation.
This nozzle is sized for operation with the unloader and steam valve
(where applicable) to provide high pressure wet steam. Replacement
of this nozzle with an improperly sized nozzle may cause operational
problems with the machine.
1. Install 25° (GREEN) steam nozzle into dual lance assembly.
2. Follow “Hot Water Operation” start-up procedures.
3. Turn steam valve completely counterclockwise to achieve maximum
outlet temperature (250°F).
OPTIONS
SHUTDOWN
1. Move the Burner switch to the OFF position.
2. Squeeze the trigger and discharge the water for a period of three
minutes to cool the heat exchanger and high pressure hose.
Insufficient cool-down periods for the high pressure hose will cause
excessive wear and eventual rupture of the hose.
3. Do not close the choke to stop the engine. Backfire or engine damage
may occur.
4. Move the engine key switch to the OFF position.
5. Turn off the water supply and trigger the gun momentarily to relieve
trapped pressure.
Disconnect and drain the high pressure hose, gun, and lance. Wipe the
unit clean. Store in a non-freezing environment.
NOTICE
Upon initial start-up, water will begin turning hot in approximately 20
seconds and will reach maximum temperature within 2-1/2 minutes
providing that the trigger gun remains open. The burner will not fire
when the trigger is released.