Xstream X-HWTR3524GEN, Руководство по эксплуатации

Страница: 29 / 40

29
MAINTENANCE - EVERy 12 MONTHS
DELIME COIL – A loss in pressure may signify that the coil needs to de
delimed. Do this procedure on a periodic basis.
1. Mix deliming powder/solution according to package directions.
2. Remove the nozzle from the wand. Place a nylon stocking over the
wand assembly to collect debris, then place the wand assembly into
the float tank.
3. Ensure the trigger gun is open and start the engine to allow water to
circulate through the system. Allow process to continue for 2-4 hours
(Consult deliming agent package directions for exact time).
4. Once process is complete, turn off engine. Drain and clean the
float tank, remove the nylon stocking, and clean the gun and wand
assembly.
5. Flush the entire system with clean, fresh water and place the nozzle in
the wand assembly.
6. Dispose of deliming solution according to local, state, and federal
regulations.
TEST VOLTAGE AND AMP DRAW - Use a voltmeter and amp meter to
test the machine for correct voltage and amperage. If you do not have
these instruments or are unsure of how to perform these tests, this
procedure should be performed by an authorized service technician.
INSPECT BURNER FUEL PUMP INTERNAL FILTER – This procedure
should be performed by an authorized service technician.
CHECK BURNER ELECTRODES - This procedure should be performed
by an authorized service technician.
REPLACE FUEL NOzzLE - This procedure should be performed by an
authorized service technician.
maintenance