Xstream X-HWTR3524GEN, Руководство по эксплуатации

Страница: 25 / 40

25
ADjUSTABLE THERMOSTAT:
Regulates the maximum discharge temperature. Turn the dial to the
desired maximum discharge temperature. This may cause the burner to
fire intermittently.
BALL VALVE
1. Connect hose from auxiliary tank to open port on the 3-way ball valve.
2. Use the selector lever on the ball valve to allow water to flow from the
auxiliary tank to the pump.
3. The water level in the auxiliary tank must always be higher than the
pump inlet. This will ensure gravity feed of water to the pump. Failure
to keep the water level above the pump inlet will result in the pump
running dry and damage to the wet end of the pump.
DUAL GUN:
Dual Gun Option also requires the Trapping Unloader Option. This option
splits flow between two discharges. Outlet Pressure at both guns will be
the same as the unit’s rated pressure.
HIGH PRESSURE DETERGENT:
1. Refer to “Risk of Bodily Injury / Detergents” pg. 8-9. Be certain to wear
protective safety attire as stated on pg. 12.
2. Prepare detergent solution according to label directions. (Never pump
acids, alkalines, abrasive fluids or solvents through the unit. Due to
the unknown and often corrosive characteristics of many detergents
commonly used in the pressure washer cleaning industry, it is
recommended to use only mild detergents with this unit.)
3. Fully immerse the strainer end of the clear vinyl detergent hose into the
detergent solution.
4. To apply solution; unlock the trigger gun and squeeze the trigger. In
a few moments a detergent/water mixture will exit the nozzle. Start
spraying the lower portion of the surface being cleaned and move up,
using long overlapping strokes. Applying from the bottom up helps
avoid streaking. Allow to soak briefly. Avoid working on hot surfaces
or in direct sunlight to minimize the chances of the detergent drying,
which may result in damaging surfaces. Be certain to apply cleaning
solution to a small section at a time.
5. To rinse; lock the trigger gun in the “OFF” position. Turn the detergent
metering valve to the “OFF” position. Unlock the trigger gun and spray.
It will take about 30 seconds to purge all detergent from the line. For
best rinsing results, start at the top and work down.
6. Siphon a gallon of water through the detergent injection system after
each use. This prevents the possibility of corrosion or detergent
residue causing mechanical problems during the next use.
operation