XLT Ovens XLT TS Series, Руководство пользователя

Страница: 2 / 33

XD9010-TS Rev D 7/2008
Installation & Operation Manual
1
WARNING & SAFETY INFORMATION
• Post in a prominent location instructions to be followed in the event you smell gas. This
information can be obtained by consulting your local gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable
liquids or vapors in the vicinity of this or any other appliance.
WARNING: Improper installation, adjustment, alteration, service or maintenance can
cause property damage, injury, or death. Read the installation, operating and maintenance
instructions thoroughly before installing, using, or servicing this equipment.
• In the event a gas odor is detected, shut off the gas at the main shutoff valve immediately.
Contact your local Gas Company or supplier.
• Do not restrict the flow of combustion and/or ventilation air to the unit. Provide adequate
clearance for operating, cleaning, and maintaining the unit and adequate clearance for
operating the gas shutoff valve when the unit is in the installed position.
• Keep the area free and clear of combustible material.
• Ovens are certified for installation on combustible floors.
An electrical schematic is located inside the control box of the oven and on pages 29-31
of this manual. Disconnect input power to the unit before performing any maintenance.
•
This unit requires a type II ventilation hood, which has make-up and exhaust air to ensure
adequate air supply. The installation should conform to local codes and the National Fire
Protection Association Code, ANSI/NFPA 70, and the National Electrical Code.
• This unit may be operated with either natural gas or propane fuel as designated on the
nameplate label located on the back of the unit.
• This unit must be operated by the same voltage, phase, and frequency of electrical power as
designated on the nameplate label located on the back of the unit.
Minimum clearances must be maintained from combustible and noncombustible construction
materials. See spacing information on page 18.
• Follow all local codes when installing this unit. In the absence of local codes, the installation
must conform to the National Fuel Gas Code, ANSI Z223.1, latest version, Natural Gas
Installation Code, CAN/CGA-B149.1, or the Propane Installation Code, CAN/CGA-B149.2,
as applicable.
• Follow all local codes to electrically ground the unit. The installation must conform to the
National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.2, as
applicable.
• PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.