Xilin CDDR, Руководство по эксплуатации, Страница: 55 / 60

51
fork-lift truck, cross-country fork-lift truck , stride- truck and platform carrying vehicle)
moves, the load surface must be in a upgrade direction.
F) When the truck works on various slopes, the load and the load bearing device must tiltt
backward (if possible), and the driver can only elevate the load’s height that is enough for
running through the road surface and local barrier.
14.2.3.4 Get across a gap
It must be ensured that under hanging devices (such as: lamps, pipeline and fire extinguishing
system) there is an enough clearance height.
Before getting across the passage and door, it must be ensured that there is an enough gap
among the vehicle, the driver and the load.
14.2.3.5 Working in road truck and railroad vehicle
Before a motor-driven industry truck runs on (or run down) the road vehicle or railroad vehicle,
some necessary measures must be taken to prevent road truck and railroad vehicle from
moving.
Before a semi- trailer that is not linked with a tractor runs on the road truck or railroad truck ,it
must be ensured that the supporting part of the stilt of the semi- trailer is located at the
supporting position.
Before a motor-driven industry truck runs on the road vehicle or railroad vehicle, it must be
ensured that the floor board can endure all the weight of the industry vehicle, load and the
driver. Besides, it is required to check the plank to see if there are crashes, holes or other
damages.
When the industry truck works on high place or platform, it is forbidden to move other truck by
industry truck. It is also prohibited to close railroad truck’s door by industry truck except for one
case that the industry truck is equipped with a special device and the driver has also been
trained how to use this device.
If possible, the truck should cross over the railway virgule.
14.2.3.6 The truck operating on the gangplank or transition board
Before the motor industrial truck pass the gangplank or transition board, it is necessary to
make sure the firm of the board.
The overall weight of the truck should not excess the rated capacity of the gangplank or the
transition board.
When passing the gangplank or the transition board, the driver should drive the truck carefully
and slowly.
14.2.3.7 The use of the truck in elevator (lifter)
Before the motor industrial vehicle driving into the elevator (lifter), it is necessary to make sure
the elevator (lifter) can endure the over all weight of the truck, load and drivers.
Before allow the truck driving in or out of the elevator (lifter),all other personnel should leave
away from the elevator(lifter).
After the bridge box floor of the elevator (lifter) is even to the ground, the truck should slowly
driving in as the positive direction.
It should be the load go into the elevator (lifter) first not the driver, this is specially adopted to
the walking type truck.
After the truck driving into the elevator (lifter), it is necessary to put the control device in the
central position. switch off the power, and tighten the brake.
14.2.3.8 Parking
After the driver leaving, the carrying device must lower to the lowest position, put the control