Xicom XTS-200C, Руководство по эксплуатации и установке

Страница: 54 / 168

MNC-0300-011 16 of 26 Revision H
Unpacking and Installation
RF Inhibit with External Source
Caution
Do not mix internal and external references because there
may a difference in ground potential between the external
source and the HPA. Failure to comply could result in
damage to the equipment.
Achtung
Wenn ein unterschied im Ground potential zwischen
äusseren quelle und HPA vorhanden ist, die inneren und
äusseren Referencen nucht mischen. Die Nichtbeachtung
kann zu Schäden am Gerät Führen.
Refer to Figure 8. J1-g can be driven from an external voltage source of
+5 to +15 VDC. In this case J1-Y should be connected to the ground
reference of the external supply to prevent damage to the HPA. RF will be
inhibited when Switch A is closed.
Figure 8, RF Inhibit with External Source
RF Inhibit with Switch A Opened
Refer to Figure 9. The RF Inhibit circuit also can be used with inverted
logic. The figure illustrates a RF inhibit circuit using an external resistor.
RF will be inhibited when switch A is opened.