Xicom XTS-200C, Руководство по эксплуатации и установке

Страница: 102 / 168

MNC-0500-010 30 Revision D
Solid State Power Amplifier Communication and Protocol
Miscellaneous Setup
Command Byte : 'P'
Function : Miscellaneous Setup
Parameters: “CX” to set Configuration Mode.
X is the redundancy mode you wish to operate.
0 — is single thread no waveguide switch.
1 — is redundant system with one waveguide switch (1:1 configuration.)
2 — is power combined system with two waveguide switches (1+1 configuration.)
3 — is redundant system with a load switch on the output (1:1 w/load.)
4 — Reserved
Parameters: IX to enable and disable Gain Temperature Compensation. X = 0 to
disable; X = 1 to enable.
Parameter: JXX to set ambient room temperature in degrees C. XX = 20 to 60 °C
Parameter: EX
X is the Ethernet mode or parameter you wish to set.
D = Bring interface Down (disable.)
U = Bring iinterface Up (enable.)
Waveguide Switch Control
Command Byte: ‘U’
Format:
‘U3’ Activate override mode and switch in Amplifier Switch 2.
‘U2’ Activate override mode and switch in other Amplifier Switch 2.
‘U1’ Activate override mode and switch in Amplifier Switch 1.
‘U0’ Activate override mode and switch in other Amplifier Switch 1.
‘UM’ Activate overide mode.
‘UA’ Terminate overide mode, activating automatic mode.
Notes: When sending a ‘U3‘, ‘U2’, ‘U1’ or ‘U0’ command, also send a ‘UM’ command
to the other amplifier to prevent unwanted automatic-mode switches.
Compatibility: For Redundant ODUs only