Xicom XTS-200C, Руководство по эксплуатации и установке

Страница: 103 / 168

MNC-0500-010 31 Revision D
Solid State Power Amplifier Communication and Protocol
Set Serial Configuration
Command Byte : 'X'
Function : Configures serial communications on the specified port and sets the unit
address. Use this command carefully as it could cause you to lose communications
with the amplifier. See the
Get Serial Configuration query for a related command. To
configure the serial port, use Parameter Format 1. To configure RS-485, use
Parameter Format 2.
Parameter Format 1 : "CBBBBBBPDS"
C Communications port; 1=COM1, 2=COM2 (COM1 = RS-232 port, COM2 = RS-
485 port.)
BBBBBB Desired baud rate:
038400, 019200, 009600, 004800, 002400, 001200
P Parity, 'N', 'O', or 'E'.
D Data bits, '8' or '7'.
S Stop bits, '1
Parameter Format 2: “RABC”
Response : "ABC"
A ‘4’ or ‘2’ Wire
B ‘T’ (Terminated) or ‘U’ (Unterminated)
C RS 485 address
Parameter: A
Sets the address of the amplifier.
Notes :
1) The parameters listed represent all options currently available.
2) The leading zero on the baud rate is there to facilitate selection of higher baud rates
in future software revisions.
3) Amplifiers currently support just two data/stop configurations: 8/1 and 7/1. Thus byte
"S" is a placeholder.
4) Parity is not supported for 8 data bits. Parity will be disabled if 8 data bits are
selected.
Compatibility: Not available when talking to an amplifier via Digital Outdoor
Controllers.