18
CN3200 Dual Band Routing Modem - Installation Guide - G7604 - Release 1.0
1.
Select an appropriate location and, using the supplied U-bolt mounting bracket, lightly secure
the CN3200 Modem/xMax Antenna assembly to the antenna mast.
2.
Orient the antenna towards the xMax Network station and then securely tighten the nuts on the
U-bolt.
3.
Using the supplied bracket and hardware, lightly secure the 2.4 GHz Panel Antenna to the
antenna mast.
4.
Orient the antenna towards the xMax Network station and then securely tighten the nuts on the
U-bolt.
5.
Secure the supplied coaxial cable to the connectors on the 2.4 GHz antenna and the CN3200
Modem.
6.
Run Ethernet cable from the indoor CN3200 Modem PoE power supply location to the CN3200
Modem/Antennas location.
IMPORTANT
To ensure proper operation:
The maximum length of this cable run
MUST
be less than 100 M (109 yds.)
Outdoor-rated foil-shielded Ethernet cable
MUST
be used.
7.
Attach two supplied ferrite cores to the CN3200 Modem end of the Ethernet cable, as shown in
the wiring diagram.
8.
Attach the supplied weatherproof Ethernet connector to the Ethernet cable.
9.
Secure the Ethernet cable to the connector on the mounted CN3200 Modem.
Complete the remainder of the installation at the indoor xMax Mobile Control Center location.
10.
At the customer end of the Ethernet cable run, install a PoE Surge Protector at the location
where the cable enters the building.
IMPORTANT
The PoE Surge Protector
MUST
be properly grounded.
11.
Attach two ferrite cores to the PoE Surge Protector end of the Ethernet cable, as shown in the
wiring diagram.
