Xerox Phaser 6180, Руководство по обслуживанию, Страница: 251 / 616

Phaser 6180 Color Laser Printer Service Manual 4-17
General Troubleshooting
Edit NVM Edit NVM
■
Ad0000=00000000*
■
Please wait
<Press the Left or Right
button to move the
cursor>
<Press the
Up or Down
button to change the
value at the cursor>
<Press the
Set button to
save the value in Engine
NVM>
<Press the
Cancel button
to move one level up the
menu>
Displays the current NVRAM value.
Use this function to edit NVRAM
information.
Save NVM Save NVM
■
SaveNVM MCU -> ESS
OK?
■
Saved
■
Please wait
<Press the Set button to
save the value in the
Controller NVM>
<Press the
Cancel button
to move one level up the
menu>
Saves the NVRAM information of the
Engine in the Controller. NVRAM
addresses to be saved are as follows:
1000-10FF, Total: 256Byte
Note: Information saved in the
Controller NVM can be initialized using
Clear All NVM .
Load NVM Load NVM
■
LoadNVM MCU -> ESS
OK?
■
Processing
■
Loaded
■
Please wait
<Press the Set button to
load the value saved in
the Controller NVM to the
Engine>
<Press the
Cancel button
to move one level up the
menu>
Loads NVRAM information of the
Engine saved in the Controller into the
Engine.
1000-10FF / 1100-11FF / 1200-12FF
Note: Information saved in the
Controller NVM can be initialized using
Clear All NVM .
Initialize Slave Initialize Slave
■
Initialize Slave OK?
■
Processing
■
Initialized
■
Please wait
<Press the Set button to
run Slave Initialization>
<Press the
Cancel button
to move one level up the
menu>
Initializes Slave.
Service Diagnostic Test Table (continued)
Test Control Panel Display Test Description