Xerox Phaser 6180, Руководство по обслуживанию, Страница: 167 / 616

Phaser 6180 Color Laser Printer Service Manual 3-41
Error Messages and Codes
4 Perform the Toner Motor test: Service
Mode > Engine Diag > Motor Test >
Toner Motor .
■
Yellow Toner Motor (page 4-47)
■
Magenta Toner Motor (page 4-48)
■
Cyan Toner Motor (page 4-49)
■
Black Toner Motor (page 4-50)
While testing the Toner Motor, close
the Interlock Harness.
Check the gear
of the Auger for
damage. If the
gear is
damaged,
replace the
Dispenser
(page 8-56). Go to step 5.
5 Check the Dispenser wiring harness
connectors.
■
Yellow: P/J18 and P/J181
■
Magenta: P/J18 and P/J182
■
Black: P/J18 and P/J183
■
Cyan: P/J18 and P/J184
Are the connectors securely
connected?
Go to step 6. Reconnect the
connectors. Go
to step 6.
6 Does the error still occur? Go to step 7. Complete.
7 Check the Top LV Harness for
continuity.
1. Disconnect P/J Harnesses.
■
Yellow: P/J18 and P/J181
■
Magenta: P/J18 and P/J182
■
Black: P/J18 and P/J183
■
Cyan: P/J18 and P/J184
2. Check continuity between P/J
connectors:
■
Yellow: P/J18 <=> P/J181
■
Magenta: P/J18 <=> P/J182
■
Black: P/J18 <=> P/J183
■
Cyan: P/J18 <=> P/J184
Go to step 8. Complete.
8 Check the Dispenser signal.
1. Disconnect P/J18 from the MCU
Board.
2. When the Interlock Switch is
activated, is there +24 V across:
■
Ground <=> P/J18-A1/P/J18-A2
(Yellow)
■
Ground <=> P/J18-A7/P/J18-A8
(Magenta)
■
Ground <=> P/J18-B1/P/J18-B2
(Black)
■
Ground <=> P/J18-B7/P/J18-B8
(Cyan)
Replace the
Dispenser
(page 8-56). Replace the
MCU Board
(page 8-87).
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No