Xerox Phaser 2135, Руководство по расширенным функциям и устранению неисправностей

Страница: 101 / 153

88 Phaser 2135 Color Printer
Troubleshooting
EE-Transfer Belt Missing Fault The transfer belt is either missing or must be
reseated to be recognized by the printer. Turn off
the printer, make sure the transfer belt is properly
installed, and turn on the printer. If the problem
persists, check the support links at:
www.xerox.com/officeprinting
/
infoSMART
.
EF-Fuser Missing Fault The fuser is either missing or must be reseated to
be recognized by the printer. Turn off the printer,
make sure the fuser is properly installed, and turn
on the printer. If the problem persists, install a
new fuser. For further assistance, visit the support
links at:
www.xerox.com/officeprinting / infoSMART .
H1-Disk Read Error Attention There was a hard disk read error that prevented
the data from being read. Press the Enter button to
clear the message. Turn off the printer, wait 15
seconds, then turn on the printer. If the problem
persists, visit the support links at:
www.xerox.com/officeprinting
/
infoSMART
.
H2-Disk Write Error Attention There was a hard disk write error that prevented
the data from being written. Press the Enter button
to clear the message. Turn off the printer, wait 15
seconds, then turn on the printer. If the problem
persists, visit the support links at:
www.xerox.com/officeprinting / infoSMART .
H3-Hard Disk Full Attention There was a hard disk full error that prevented the
data from being written. Press the
Enter
button to
clear the message. Print or delete Secure Print and
Proof Print jobs to free-up disk space.
H4-Hard Disk Formatting Attention The hard disk is being formatted. Data cannot be
written to the disk until the formatting is
completed.
H5-Hard Disk Initializing Attention The hard disk is being initialized. Data cannot be
written to the disk until the initializing is
completed.
J3-Replace Fuser Fault The fuser has reached its end of life. Install a new
fuser.
J4-Replace Transfer Belt Fault The transfer belt has reached its end of life. Install
a new transfer belt.
J n -Replace Imaging Drum
[J5-Replace Yellow Drum]
[J6-Replace Magenta Drum]
[J7-Replace Cyan Drum]
[J8-Replace Black Drum]
Fault The imaging drum has reached its end of life.
Install a new imaging drum.
Printer Management Status Messages (cont'd.)