Xerox MF Series, Техническая документация

Страница: 28 / 191

IG 252 787 467 - A - 8 -
5.3 P
RINTER OUTPUT TRAY
With both hands, slightly bend the centre part of the stacker upwards in order to insert its clips into the
notches located on the upper part of the printer. Release the stacker so that it recovers its initial shape.
6. INSTALLING THE CONSUMABLES
Refer to the User Guide.
7. START-UP AND SOFTWARE CONFIGURATION
A few seconds after switching on, as soon as the warm-up of the printer is finished, the date and the
time are displayed.
Note(s) : When the machine is switched on for the first time, the T
EST EN
C
OURS
(test in
progress) message is displayed for several minutes.
7.1 U
SER PARAMETERS
Refer to the User Guide.
7.2 I
NSTALLATION PARAMETERS
The purpose of these parameters is to adapt the fax to specific user requirements and to the telecommu-
nication standards of the country where the fax is to be installed.
At delivery, each fax is programmed with the factory test configurations. The installer can obtain a
printed listing of these parameters (key sequence
MENU , 5 , 4 , OK ).
Note(s) : It is advised to keep a paper copy of the list of these parameters at delivery.
The access to these parameters is only authorized to maintenance and/or installation technicians.
The fax is equipped with a set of logic blocks referred to as SOS (SOft Switches). Each block consists
of 8 bits called bit 1 to 8. Each bit can take a value of either 0 or 1. On the display, a block (from bit 1 to
bit 8) is read from right to left. When a configuration is first selected, the blinking cursor is always
placed on bit 8 (the bit at the left).