Xerox DocuPrint 65, Руководство по планированию установки

Страница: 31 / 60

Installation Planning Guide Installation
DocuTech 65/DocuPrint 65 2-7
Electrical requirements
CAUTION
Do not connect the power cord at this time.
USA/Canada
The printer requires a dedicated 115V AC 20 Amp grounded receptacle.
The controller requires a dedicated 115V AC 20 Amp grounded receptacle.
Europe
The printer requires a 220-240V 13 or 10 Amp grounded receptacle.
The controller requires a 220-240V 13 or 10 Amp grounded receptacle.
CAUTION
Do not remove or modify the power cord plug. Do not use a two-prong
adapter to connect the three-prong plug to an ungrounded receptacle.
Personal injury or damage to the printer could occur.
A typical USA 20 Amp receptacle is illustrated in Figure 2-9.
Figure 2-9. USA 20 Amp receptacle
• The power receptacle for the printer must be within easy reach of the
printer’s 10 ft. (3 m) power cord from the right rear corner of the printer,
and the receptacle shall be easily accessible. Do not use an extension
cord.
• If a PhoneShare device is used an additional 115V AC 15 or 20 Amp
power receptacle is required within 6 ft. (1.8 m) of the PhoneShare device
location. For detailed information about using a PhoneShare device, refer
to the section, Telephone line requirements.
• All configurations require one 115 VAC, 3 wire, 15 Amp receptacle for the
outlet strip that provides receptacles for the controller and its peripheral
devices.
• Use the power strip to connect the telephone line with the controller
external modem. The power strip has two special surge-suppressor jacks,
one labeled “In” and the other labeled “Out.” From the wall jack, insert the
phone line into the power strip “In” jack. From the power strip “Out” jack,
insert the phone line into the controller external modem.