Xerox DocuPrint 65, Руководство по планированию установки

Страница: 22 / 60

Planning for the installlation Installation Planning Guide
1-2 DocuTech 65/DocuPrint 65
Customer responsibilities
Your responsibilities prior to, during and after installation of the DocuTech 65/
DocuPrint 65 printer are:
Site Personnel
Identify a person at your site to be the primary interface with Xerox.
Site Selection and
Preparation
Select and prepare the site for DocuTech 65/DocuPrint 65 printer installation.
The following electrical, telephone, and network services are required:
Electrical requirements
USA/Canada
The printer requires a dedicated 115V AC 20 Amp grounded receptacle. The
power receptacle for the printer must meet the requirements stated on the
data plate on the rear of the printer.
The controller requires a dedicated 115V AC 20 Amp grounded receptacle.
Europe
The printer requires a 220-240V 13 or 10 Amp grounded receptacle. The
power receptacle for the printer must meet the requirements stated on the
data plate on the rear of the printer
The controller requires a 220-240V 13 or 10 Amp grounded receptacle.
CAUTION
Do not remove or modify the power cord plug. Do not use a two-prong
adapter to connect the three-prong plug to an ungrounded receptacle.
Personal injury or damage to the printer could occur.
A typical USA 20 Amp receptacle is illustrated in Figure 1-1.
Figure 1-1. USA 20 Amp receptacle
• The power receptacle for the printer must be within easy reach of the
printer’s 10 ft. (3 m) power cord from the right rear corner of the printer,
and the receptacle shall be easily accessible. Do not use an extension
cord.
• If a Phone Share device is used an additional 115V AC 15 or 20 Amp
power receptacle is required within 6 ft. (1.8 m) of the PhoneShare device
location. (For detailed information about using a Phone Share device,
refer to the section, Telephone line requirements.