Xerox 6100BD - Phaser Color Laser Printer, Руководство пользователя

Страница: 58 / 168

Problem Solving
DT6180 HandyBook
58
Area
Case #
Problem
Related Fault
Codes
Potential Solutions
/Solutions Ranked by Relevance:
Detail So
luti
ons
follo
wi
ng
Problem tab
le?
If an adjustment is made to the binder
tape length during a job, it will not take
effect until the next job is printed. If it is
necessary to adjust the binder
tape length during a job, adjust it using
the procedures in the on-line help.
F Loose binder tape
along the spine of the
completed bound
book This is a symptom of excessive moisture
in the tape. Replace the tape reel with a
new reel using the procedure, "Replace
the Binder Tape Reel," in “Replacing
Consumables”.
Refer to the binder tape storage
guidelines in the Operator Guide.
N
F Repeated tape
feeding problems,
such as binder tape
not unwinding from
the reel If the binder tape is sticking together, or if
there are cosmetic defects in the bound
book, replace the tape reel with a new
reel using the procedure, "Replace the
Binder Tape Reel," in “Replacing
Consumables”.
Refer to the binder tape storage
information in the Operator Guide.
Refer to the binder cleaning information in
the Operator Guide.
N
F Poor stitch quality or
short stitches Reliable stitching can be expected with up
to 65 sheets of substance 20 (75 g/m2) or
0.28 inch (7 mm) thick sets. Less reliable
stitching can be
expected with over 70 sheets of
substance 20 (75 g/m2).
Running intermixed stock heavier than
substance 20 (75 g/m2) will reduce the
capacity of the stitcher.
To avoid short clinches, use the stitch
override only when using a lightweight
paper. Stitch override allows the system
to run beyond the
stitching limit. The system will shut down
at 125 sheets.
Reduce the stock weight to enable the
stitching of more sheets per set.
Refer to the satisfaction guides in the
"Technical information" chapter.
N
1. Clear the Paper Jams in Areas 16
and 17
Y F 1680 Bins Exit
Sensor Fault
P12-140
2. Clean the Bins Exit Sensors
(Q1222)
Y