Xembedded XVME-689-VR7, Руководство пользователя

Страница: 46 / 94

BIOS Setup Menus
3-9
3.4 POST Memory Tests
The POST menu is used to configure POST. This menu is shown in Figure 3.4 (scrolled down more so
the full set of options can be seen.).
System Configuration Utility
Main Exit Boot Post PnP SIO Features Firmbase Misc>
POST Memory Tests Enable basic memory
Confidence test below
Low Memory Standard Test [Disabled]
1MB during POST.
Low Memory Exhaustive Test [Disabled]
High Memory Standard Test [Disabled]
High Memory Exhaustive Test [Disabled]
Click During Memory Test [Enabled]
Clear Memory During Test [Disabled]
Post Error Control
Pause on POST Errors [Enabled]
POST User Interface
POST Display Messages [Enabled]
POST Operator Prompt [Enabled]
POST Display PCI Devices [Disabled]
POST Display PnP Devices [Enabled]
POST Debugging
POST Debugger Breakpoints [Disabled]
POST Slow Reboot Cycle [Disabled]
POST Fast Reboot Cycle [Disabled]
Device Initialization
POST Floppy Seek [Disabled]
POST Hard Disk Seek [Enabled]
Embedded BIOS® 2000 V6.0.5 – Copyright 2006 General Software, Inc.
Figure 3-4 POST memory test Menu
The following table describes the settings associated with the POST setup menu’s Memory Test section.