Xantrex GT3.0, Руководство пользователя

Страница: 44 / 110

Installation
2–16 975-0131-01-01
In this chapter only the first step, mounting the inverter and installing accessories,
is described.
Mounting steps Instructions for mounting the GT Inverter are described in the following sections:
• “Preparing to Mount the Unit” on page 2–16
• “Installing the Mounting Bracket” on page 2–17
• “Mounting the Inverter on the Bracket” on page 2–22
• “Installing Accessories” on page 2–23.
Multiple inverter
instructions Mounting instructions for multiple inverters connected in parallel are described in
“Mounting Multiple Inverters in Parallel” on page 2–23.
Special wiring instructions for multiple inverters connected in parallel are
described in “Connecting Inverters in Parallel” on page 3–10.
Preparing to Mount the Unit
Dimensions and Knockout Locations
The dimensions of the inverter and the mounting bracket and some of the
knockout locations on the wiring box are shown in Figure 2-7.
Four 2 cm or 2.5 cm (3/4 inch or 1 inch) knockouts are provided on the back and
bottom of the unit to accommodate wiring:
• two on the bottom of the wiring box, on either side of the AC/DC Disconnect
Switch
• two on the back of the wiring box.
Four 2 cm (3/4 inch) conduit holes on the sides of the wiring box are filled with
plastic plugs, which can be removed to insert conduit nipples as required for
inverters mounted in parallel. One or two of these side conduit holes may be used
to accommodate communications wiring for multiple inverters mounted in
parallel.
Knockout Preparation
Remove your choice of knockouts from the wiring box to facilitate conduit
installation for wire runs. This is much easier to do prior to mounting the inverter.
Important:
Ensure there are no metal shavings left in the inverter after removing the
knockouts. Be sure to install bushings or conduits in the knockout holes to protect the
wires from damage.
If installed outdoors, conduit must be sealed where it enters the wiring box.