Xantrex FREEDOM HF 1000, Руководство по установке

Страница: 37 / 70

Basic Installation Procedures
975-0395-01-01 1–19
This guide for use by qualified installers only
Step 5: Connecting AC Output to an Existing AC Circuit
Do not connect the Freedom HF to an AC branch circuit that has
high-power consumption loads.
The Freedom HF will not operate electric heaters, air conditioners, stoves,
and other electrical appliances that consume more than 1000 watts
(
Freedom HF 1000 ) or 1800 watts ( Freedom HF 1800 ).
A Xantrex-tested and approved GFCI must be connected to the Freedom
HF AC output, and on every receptacle connected to the AC hard wired
installation. Other types may fail to operate properly when connected to
the
Freedom HF . Although you can reuse the factory-installed GFCI,
Xantrex has also tested and approved the following GFCIs for use with
the
Freedom HF :
For more information about GFCIs, see the application note “Using GFCI
Receptacles on Xantrex Inverters and Inverter/Chargers” in the Document
Library at
www.xantrex.com .
WARNING: Shock, fire, and energy hazards
Make sure wiring is disconnected from all electrical sources before handling. All
wiring must be done in accordance with applicable local and national electrical
wiring codes.
WARNING: Shock hazard and equipment damage
Do not connect any AC source (such as a generator or utility power) to the
AC wiring output of the
Freedom HF .
The Freedom HF will not operate if its output is connected to AC voltage from
another source, and potentially hazardous or damaging conditions may occur.
These conditions can occur even if the inverter is off.
Make Model
Hubbell GFR5252
Leviton 6598
8598
FreedomHF_IC_01-Installation.fm Page 19 Monday, December 24, 2007 9:47 AM