X-POWER 9027244, Руководство пользователя

Страница: 9 / 32

The Backstop supports the Sanding Belt for sanding flat
surfaces. It is held in place on the Frame with two screws
through the opening in the Belt Table. To sand curved
surfaces, remove the Backstop, or back it away from the
Sanding Belt.
Sanding
Belt
Backstop
The Backstop
Disc Setup
Disc Table Assembly / Removal
Dust Chute Removal
1. Unthread and remove the four Screws
holding the Dust Chute in place and remove
the Dust Chute, Screws and Washers.
2. When reinstalling the Dust Chute, position the
opening facing the back of the unit, as shown at right.
Figure H
1. To remove the Disc Table Assembly:
a. Unthread and remove the Handles on both sides of
the Disc Table.
b. Lower the Table and slide it away from the
Sanding Disc and remove it from the Sander.
2. To install the Disc Table Assembly:
a. Align the pins in the Disc Table with the slots on the
Disc Guard.
b. Slide the Disc Table Pins up and in and attach in place
with the Handle Assemblies.
3. Check that the Disc Table is 1/16" or less from the
Sanding Disc. To adjust:
a. Loosen the Adjustment Screws on the Disc Guard.
b. Slide the Disc Guard / Disc Table assembly to the
desired distance from the Sanding Disc.
c. Tighten in place.
Figure J
Figure I