X-POWER 9027244, Руководство пользователя

Страница: 11 / 32

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its
“OFF” position and unplug the tool from its
electrical outlet before assembling or making any adjustments to the tool.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.
Moving guards must move freely and close instantly.
Install Sanding Belt and Sanding Disc and
adjust all tables and Guards (pages 7-10).
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
General Operating Instructions
1. Setup the Sander including adjusting tracking of the
Sanding Belt, checking that all guards are in place,
adjusting the Miter Guide if needed, and checking
that both tables are 1/16" maximum from the sanding
surfaces and are squared to the sanding surface.
2. Check that the ON/OFF Switch is off, then plug the
Power Cord into a 120V~/60Hz grounded outlet.
3. Turn the ON/OFF Switch ON.
4. Wait for the sanding surfaces to
come up to full speed.
5. Holding the workpiece firmly on the table
surface, slide the workpiece into contact
with the sanding surface applying light
pressure against the sanding surface.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
Figure M: Direction of Rotation
CAUTION: Only contact the downward side of the
rotating Sanding disc. Bringing the workpiece in contact
with the upward rotation of the disc may cause the
workpiece to fly up or kickback which may result in injury.
6. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of
children’s reach.
Operating Instructions
M
A
IN
T
E
N
A
N
C
E
OP
E
R
A
T
IO
N
SET
U
P
SA
F
ET
Y