X-POWER 9027244, Руководство пользователя

Страница: 3 / 32

General Tool Safety Warnings (cont.)
13.
DON’T OVERREACH. Keep proper
footing and balance at all times.
14.
MAINTAIN TOOLS WITH CARE. Keep tools sharp
and clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
15.
DISCONNECT TOOLS before servicing;
when changing accessories, such as
blades, bits, cutters, and the like.
16.
REDUCE THE RISK OF UNINTENTIONAL
STARTING. Make sure switch is in
off
position before plugging in.
9.
USE PROPER EXTENSION CORD. Make sure your
extension cord is in good condition. When using
an
extension cord, be sure to use one heavy
enough to carry the current your product will
draw. An undersized cord will cause a drop in
line voltage resulting in loss of power and
overheating. Table A shows the correct size to
use depending on cord length and nameplate
ampere rating.
If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
10.
WEAR PROPER APPAREL. Do not wear
loose
clothing, gloves, neckties, rings, bracelets, or
other jewelry which may get caught in moving
parts. Nonslip footwear is recommended.
Wear protective hair covering to contain long hair.
11.
ALWAYS USE SAFETY GLASSES. Also use
face or dust mask if cutting operation is dusty.
Everyday eyeglasses only have impact resistant
lenses, they are NOT safety glasses.
12.
SECURE WORK. Use clamps or a vise to hold
work when practical. It’s safer than using your
hand and it frees both hands to operate tool.
17.
USE RECOMMENDED ACCESSORIES.
Consult the owner’s manual for recommended
accessories. The use of improper accessories
may cause risk of injury to persons.
18.
NEVER STAND ON TOOL. Serious injury
could occur if the tool is tipped or if the
cutting tool is unintentionally contacted.
19.
CHECK DAMAGED PARTS. Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that
it will operate properly and perform its intended
function
– check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
20.
DIRECTION OF FEED. Feed work into
the sanding surface against the direction
of rotation of the sandpaper only.
21.
NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER OFF.
Don’t leave tool
until it comes to a complete stop
Table A: RECOMMENDED MINIMUM WIRE GAUGE
FOR EXTENSION CORDS
(120 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25′ 50′ 100′ 150′
0
– 6
18 16 16 14
6.1
– 10
18 16 14 12
10.1
– 12
16 16 14 12
12.1
– 16
14 12 Do not use.