X-POWER 9027244, Руководство пользователя

Страница: 7 / 32

Belt Setup
Belt Installation / Replacement
1. Loosen and remove the Table Lock Handle, the Toothed Washer,
and remove the Belt Table from the Sander. Leave the Bolt inside
the Frame in place.
2. Unthread the two screws holding the Lower Belt Guard in place
and remove the Lower Belt Guard.
Figure B
3. Unthread and remove the Screw holding the Upper Belt Guard in
place. Remove the Upper Belt Guard.
4. Unthread and remove the Knob holding the Belt Cover in place.
5. Remove the Belt Cover by pulling up on the Belt Cover so the
Flanges come out of the base of the Sander.
Screw
Washer
Upper Belt Guard
Knob
Belt Cover
Flanges
Figure C
6. Turn the Tension Knob counterclockwise to loosen the belt
tension.
7. Slide the old Belt off and replace with a new Belt.
8. Tighten the Tension Knob, turning clockwise.
9. Replace the Guards, Belt Cover and the Belt Table (see page 8).
Proceed to Adjusting Belt Tracking.
Wheels
Tension
Knob
Belt
Direction
of Belt
Driving
Wheel
Figure D
M
A
IN
T
E
N
A
N
C
E
OP
E
R
A
T
IO
N