X-PERFORMER XPCACG20LI, Оригинальное руководство пользователя

Страница: 38 / 60

1.7. Do not exceed 100W/m³ of free room. The minimum volume of the room must be larger
than 100m³.
1.8. Do not obstruct the inlet or outlet sections of the heater.
1.9. If the heater has to work for a long period at its maximum capacity, it’s possible that ice
will form on the cylinder. This is due to excessive vapour withdrawal. Not for this reason,
or for any other, should the cylinder be heated. To avoid this effect, or at least to reduce
it, use a large cylinder or two cylinders linked together (figure1).
1.10. Do not use the heater in cellars, basements or in any room below the ground level.
1.11. In case of malfunction, please contact the technical assistance service.
1.12. After use, turn the gas cylinder tap off.
1.13. The gas bottle must always be replaced following safety rules away from any possible
source of ignition.
1.14. The gas hose must not be twisted or bent.
1.15. The heater must be placed where there is no risk of fire, the hot air outlet must be at
least 3m from any flammable wall or ceiling and must never be directed towards the gas
bottle.
1.16. Only use original gas hose and spare parts.
1.17. Heaters described in this leaflet are not intended for domestic use.
1.18. In the case that a gas leak is found or suspected, immediately close the gas cylinder,
switch the heater off and do not use it again until it has been checked by a qualified
service centre. If the heater is installed indoors, provide a good ventilation by opening
door and windows completely. Do not produce sparks or free flames.
1.19. If in any doubt contact your supplier.
1.20. Use a cylinder of maximum 50 kg.
2. INSTALLATION
2.1 Connect the heater to a suitable electrical outlet 100-240V~, 50-60Hz power source or
use the DC20V battery
2.2 Make sure that the machine is properly earthed.
2.3 Connect the gas supply hose to the pressure regulator and connect the regulator to a
suitable PROPANE cylinder.
2.4 Open the tap of the cylinder and check the supply hose and fittings for gas leak. For this
operation it is recommended to use an approved leak detector.
2.5 NEVER USE NAKED FLAMES.
2.6 For automatic appliances, connect the room thermostat to the socket on the appliance
and adjust it to the required temperature.