8
Technical support:
EMEA/ROW: +44 (0) 1793 230 343
IR/RS-232 CONTROL CONNECTION
Initial Connection
Before Installation
!
70m/230ft @ 1080p and 4K @ 35m/114ft video are the maximum recommended transmission distances for this
model and denotes recommended transmission conditions including straight cable runs with no electrical interference,
bends, kinks, patch panels or wall outlets. If any of the above is a factor in your installation, transmission range may be
affected – take care to avoid where possible.
!
WyreStorm recommends using supplied mounting brackets to secure the receiver to a flat surface behind/near the
display device. Sudden movement of these devices could lead to loss of picture/sound if connections become loose or
strained, resulting in unnecessary service call-backs.
!
If unsure of positioning, IR sensors can be located on devices by shining a flashlight onto the fascia of the device
- the IR sensor should be identifiable as a small round sensor behind the panel. Consult your device manufacturer
handbook if difficulties are experienced.
Setup and Operation
1
*VUULJ[HNVVKX\HSP[`^LSS[LYTPUH[LK*H[JHISLVMUVTVYL[OHUTM[MVYWVYTM[MVY2IL[^LLU[OL
/+);VY<;76<;VM[OL[YHUZTPZZPVUKL]PJLTH[YP_VY[YHUZTP[[LY[V[OL/+);05VY<;7050UW\[VM[OL9?76/
0M[OL[YHUZTPZZPVUKL]PJLPZ7V/LUHISLK[OL7V/M\UJ[PVU^PSSJHYY`WV^LYHSVUN[OLSLUN[OVM[OLJHISL[VWV^LY[OLYLJLP]LYZV
UVSVJHSWV^LYPZYLX\PYLKH[KPZWSH`aVULZ
2[YHUZTPZZPVUKL]PJLYLX\PYLK
NOTE: Optional 12V power connectivity for local mains connection is available if required - for example, if installation
conditions, or cable quality is too low to carry power, or if a non-PoH enabled transmission device is being used.
2
*VUULJ[[OL/+40KPZWSH`KL]PJL[V[OL/+406<;VM[OL9?76/
NOTE: a WyreStorm EXP-CON-4K-DD scaler may be required for installations combining both combined 4K and 1080p
HD equipment.
3
*OLJR76>,9:;(;<:3052SPNO[ZHYLPSS\TPUH[LKVU[OLYLJLP]LY[VPUKPJH[LZ\JJLZZM\SJVUULJ[PVU^P[OHSP[/+*7
PSS\Z[YH[PUN[OLWYLZLUJLVMLUJY`W[PVU^P[OPU[OLZPNUHS*VYYLJ[VWLYH[PVUPZPUKPJH[LKI`ZVSPK76>,9HUK3052SPNO[ZHUKMSHZOPUN
:;(;<:HUK/+*7SPNO[ZPM/+*7PZWYLZLU[PU[OLZV\YJLZPNUHS
IR/RS-232 Control Connection
4
-VY[^V^H`09JVU[YVSVMJVUULJ[LKZV\YJLHUKKPZWSH`JVUULJ[HU09LTP[[LYMYVT09;?WVY[VM[OL[YHUZTPZZPVUKL]PJLHUK
H[[HJO[OLLTP[[LYL`L[V[OL09YLJLP]PUNHYLHVM[OLZV\YJLKL]PJL*VUULJ[HUV[OLY09LTP[[LYMYVT[OL09;?WVY[VM[OL9?
76/[V[OL09YLJLP]PUNHYLHVM[OLKPZWSH`KL]PJL
!
Care should be taken to firmly attach emitters directly over the infrared receiving area of devices. Location of the
LTP[[LYL`LTH`ULLK[VILHKQ\Z[LKSH[LY[VHJOPL]LILZ[09WLYMVYTHUJL
0M\UZ\YLVMWVZP[PVUPUN09YLJLP]PUNHYLHZVMKL]PJLZJHUILSVJH[LKI`ZOPUPUNHMSHZOSPNO[VU[V[OLMHJPHVM[OLKL]PJL[OL09
ZLUZVYZOV\SKILPKLU[PMPHISLHZHZTHSSYV\UKVIQLJ[ILOPUK[OLWHULS*VUZ\S[`V\YKL]PJLTHU\MHJ[\YLYOHUKIVVRPMKPMMPJ\S[PLZHYL
L_WLYPLUJLK
5
-VY\ZL^P[OHU09IHZLKJVU[YVSZ`Z[LTHU093PURJHISLZVSKZLWHYH[LS`ZOV\SKILJVUULJ[LKIL[^LLU[OL099?WVY[VM[OL
[YHUZTPZZPVUKL]PJL[V[OLJVU[YVSZ`Z[LT\ZLK
