600-00174-001
Rev. 03, 13 May 2008
53
WSI AV-300/350 Installation Manual
R
EMOTE
C
ONTROL
U
N
-P
AIRING
P
ROCEDURE
(F
OR
A
UDIO
-
ENABLED
U
NITS
O
NLY
)
NOTE:
Only use this procedure when an AV-350 Receiver is replaced with a different
unit.
UN-PAIRING - If the AV-350 is replaced with a new AV-350, un-pair the existing 420-0350-
RM Remote Control from the previous AV-350 using the following steps:
1.
Press any button to activate the 420-0350-RM Remote control.
2.
Press and hold the "Set" button in upper left corner until remote displays "SIRIUS
SETUP or INITIAL SETUP."
3.
If it displays "INITIAL SETUP," use the arrow buttons to scroll through to "SIRIUS
SETUP."
4.
Press the "ok" button located right under the screen, the remote will display "NODES."
5.
Press the right arrow and the 420-0350-RM will display "NETWORK,"
6.
Press "ok," and the remote will display "NETWORK RESET."
7.
Press "ok," the remote will display "SUCCESSFUL."
After a successful un-pairing, the 420-0350-RM can be paired to a different AV-350 receiver
using the Remote Control Paring Procedure.
R
EPLACING
B
ATTERIES IN THE
420-0350-RM
R
EMOTE
C
ONTROL
To change the batteries in the 420-0350-RM Remote Control, slide the battery cover off the back
of the remote, replace the 4 AAA batteries, and replace the back cover. Removing batteries
briefly and replacing them promptly will not typically result in a need to re-pair the 420-0350-
RM Remote Control with the AV-350, however, it is possible for the devices to become
unpaired. In the event that pairing is lost, repeat the pairing procedure as defined in the previous
section.
