WPI EZ Anesthesia, Инструкция по эксплуатации

Страница: 9 / 16

EZ Anesthesia
World Precision Instruments 5
Water Pump And Surgical Pump Setup
1. Connect both tubes from the surgical bed to the two water pump tubes.
2. Before filling the pump, be sure the in/out water tubes between the pump and
surgical bed are connected.
3. For proper performance, the pump should be positioned at or above the surgical
bed level, not below. Placing the pump below the bed can result in water overflow
and water possibly leaking on to the floor, or it could reduced the motor life.
4. Open the cap on the top of the pump. Fill the pump with room temperature
water to just above the operating water level indicator line on the side of the
pump and replace cap.
5. Turn on the pump to begin circulating water to the surgical bed and choose
appropriate temperature setting. The recommended setting for one or two beds
is LOW. For three or more beds, the recommended setting is HIGH.
6. The operating water level will quickly diminish. If the water level falls below the
indicator line, turn off the pump, remove cap and add water up to the indicator
line. Do not exceed the indicator line level. Replace the cap and operate the
pump. Repeat steps 4 and 5 until the water stabilizes at the line level.
7. Once the system is stabilized at the line level, run the pump continuously. The
bed will reach the temperature set point in approximately twenty minutes.
NOTE: Multiple surgical beds can work with one water pump.
A. Connect pump output to first bed input.
B. Connect first bed output to second bed input.
C. Connect second bed output to pump input.
D. Additional beds may be added following this basic procedure.
Isoflurane Vaporizer Setup
Pay attention to all warnings and cautions, as these draw attention to potentially
harmful or dangerous results.
Cautions and Warnings
CAUTION : The vaporizer must ONLY be used with Isoflurane. No other agent is
acceptable and may be dangerous.
CAUTION : Isoflurane should only be used by licensed personnel. Wear
appropriate facemask and follow safety procedures as recommended by OSHA
and your facility safety officers. If you have any questions regarding safety,
please contact WPI for assistance.