Worth Data TriCoder t53, Руководство пользователя

Страница: 161 / 246

14-13
My uploaded data has the old data followed by my new
data…
•
If you upload your data and fail to delete it from the TriCoder,
when you enter DATA COLLECTION mode again, the TriCoder
assumes you want to collect more data and append it to the end of
the data file that already exists. To avoid this, be sure to press
YES when the TriCoder asks if you want to delete the data file.
When it asks ARE YOU SURE?, press YES.
I want to read more than one length I 2of 5 bar code…
•
To scan any length I 2of 5 bar code, use 00 when setting the 2 of 5
Length . If you are going to do this, you must check the length in
DATA COLLECTION to minimize the possibility of partial reads.
I 2 of 5 is very susceptible to misreads so using 00 to read all
lengths is risky and not recommended.
I need more than 15 characters for upload prefix and
suffix to upload multiple operator entered fields that I
want outputted with my main field…
•
When using Refer-backs, use {2 instead of {02 to refer back to a
particular statement. Substitute your statement numbers for the 2
in the example above. You can also use the “None Statement” for
additional refer-backs. See
Chapter 8 ; Creating custom
programs for details on Refer-backs.
Error messages for special consideration
The error messages below relate to problems that can either be solved by
resetting the TriCoder or may require repair:
CHECK LITHIUM BATTERY
This message indicates a minor memory problem that has occurred in a Flag
Byte area monitored by the TriCoder each time the TriCoder is powered up.
Further memory loss could have occurred but the TriCoder was not able to
detect a bad statement number, invalid entry type etc… The TriCoder
corrected the Flag Bytes and is letting you know that the error has occurred.
If you get this message you should:
1. Check the STATUS on the lithium battery to be sure it has at least
20% life remaining.
2. Check the existing programs, data and tables to be sure some
undetected memory loss has not occurred.
3. This message can occur if both batteries (AA and Lithium) have
been removed or if both have been depleted.