Worth Data TriCoder t53, Руководство пользователя

Страница: 48 / 246

6-1
Chapter 6
TriCoder Setup
Most, but not all of the Setup Parameters can be changed by either using the
TriCoder keypad in
Programming Mode or scanning the appropriate bar codes
on the TriCoder Setup Menu. You can also "clone" your setup from one
TriCoder to another if you have the appropriate cables and if you are using high
speed USB you can change your setup parameters using the
TriCoder Utilities
program.
Using the bar code TriCoder Setup Menu
To access the Setup using the bar coded TriCoder Setup Menu , scan the
START SETUP bar code in the upper left hand corner of the bar coded
TriCoder Setup Menu. You should hear two beeps from the TriCoder upon
scanning START SETUP and the words START SETUP should appear on
the TriCoder display. At this point you are ready to scan and change as
many parameters as you wish, following this order:
1. Scan the bar code for the parameter you want to change
2. Scan the number on the Barpad Table (to the right) that
corresponds to the setting you want to choose.
3. If the parameter requires it, scan the SET bar code. SET is
normally used to terminate a setup parameter that can have
variable input, i.e. Preamble or Postamble.
4. If you want to make more changes, go back and start at step 1
5. If you are finished, scan the END SETUP bar code in the upper
right hand corner. You should hear 3 beeps at END SETUP.
6. To reset the TriCoder back to the default settings at any time, scan
START SETUP, RESET, then END SETUP. Resetting the
TriCoder will lose any changes you have made and set the
TriCoder to the default settings (indicated by a * on the bar coded
setup menu).
Using the keypad to setup the TriCoder
To use the keypad to setup the TriCoder, you must first get into
PROGRAMMING MODE. To do this, answer NO to all Mode Menu
prompts until you see:
PROGRAMMING MODE
KEY [YES/NO]?_
Press the YES key. A password is required to proceed into
PROGRAMMING MODE:
PROGRAMMING MODE
PASSWORD?_