ECRESO FM 5kW / 10kW, user manual
–
11/2021
Page 61
WorldCast Systems SAS - 20 avenue Neil Armstrong - 33700 Mérignac (Bordeaux Métropole) FRANCE
+33 (0)5 57 928 928
–
www.worldcastsystems.com
–
BOOST
(TX.PFWD.BOOST)
–
read *
This parameter gives the boost in Wh since SmartFM was first used (on web page and front panel), or instantaneously
(with serial command).
5.7.
Input switch parameters
These parameters are available as:
Front panel
Input Switch menu
see section 6.3.6
Serial commands
INPUT and CONF
see sections 7.2.6 and 7.2.4
Embedded web site
Transmitter/Input Select pages
see section 8.4.4
INPUT SELECT
With this parameter, select the main audio source.
LINE1, LINE2, MPX1, MPX2, PLAYER or GENE
PRIORITY
With these parameters, set the level of priority for each input and thus configure the selection order for the various
audio sources.
From 1 to 7, 7 being the highest level of priority
If there is no audio, neither on the main source nor on the backup sources (or regardless of the priority level), the
transmitter will remain on (or switch back to) the main source.
LINE 1 or 2 / MPX / PLAYER parameters
These parameters are specifically available as INPUT.LINE1.SW / INPUT.LINE2.SW / INPUT.MPX.SW /
INPUT.PLAYER.SW serial commands (see section 7.2.5).
THRESHOLD
(INPUT.xx.SW.THRESH)
–
read/write
With this parameter, set the silence threshold level on the selected channel. In dBr when units are in relative mode; in
dBFS or dBu when units are in absolute mode (see definition of modes section 5.15).
From -90 to 0 dBr
SILENCE
(INPUT.xx.SW.SILENCE)
–
read/write
With this parameter, select the channel (L / R / L or R / L and R) on which silence detection must be performed (not
available on the MPX sub-menus).
L, R, ANY or BOTH
DELAY
(INPUT.xx.SW.DELAY)
–
read/write
With this parameter, set the switching delay in seconds when audio loss occurs.
From 1 to 120 s
BACK
DELAY
(INPUT.xx.SW.BACKDELAY)
–
read/write
With this parameter, set the delay before returning to the highest priority channel, in seconds.
From 0 to 30 s
